Page Comparison

Changing the 45 Degree Blade: CMC Z1, Z(9000z), 9000, 8500eSBT, 8500e, 8500, 8000, 8000RC and 8000+

Info
The 45° metal black blade cartridge* is designed to cut 45° bevels on standard 4-ply matboard. The 45° metal black blade cartridge is labeled 45° 45° Blade Cartridge is labeled “45” with a 45° Angle Symbol on the end.

Image Added

Notes:

Info
Your hardware may look different than the model pictured, but the process is still the same . The 45° blade cartridge does not support blade depths above 16. *Older systems may have a 45° plastic black blade cartridge .

Image Removed

Push the blade cartridge Blade Cartridge release lever down to eject the blade cartridgeBlade Cartridge.

Remove the blade from blade cartridge.Mind Blade from Blade Cartridge, being mindful of the sharp edge.

The blade cartridge Blade Cartridge displays a diagram of the blade Blade orientation (shown in contrast).
Place new blade Blade into cartridge Cartridge with the longest side to the right and the bevel face down, lining up the bottom hole of the blade Blade over the pin in the cartridgeCartridge.
The blade Blade should fit snugly into the recess space provided for it.

Info
NOTE: If there is any side-to-side movement of the blade Blade in the blade cartridgeBlade Cartridge, it is time to replace the blade cartridgeBlade Cartridge.

Insert the blade cartridge Blade Cartridge into the Head with the blade Blade facing toward the board Board and the notch on the back of the cartridge Cartridge facing the Head.
It should click into place.
- It can only be inserted one way.