Versions Compared

Old Version 32

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 79

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Image Removed

Rotation on V-Grooves Definition

InfoThe

Outside Rotation

controls for Swoopsor Flares

on

the outside cut on non-oval

V-Grooves

. InfoThe first cut is the interior V-Groove line and cut into

  • If the Outside cut of the V-Groove

fallout and not the matboard, and is cut in a clockwise direction. This uses the Inside
The second cut is the exterior V-Groove line and cut into the matboard and not on the

  • If the Outside cut of the V-Groove

fallout, and is cut in a counter-clockwise direction. This uses

See Also: Troubleshooting Utility for Non-Oval V-Grooves

Problem:

  • The Non-Oval V-Groove cuts with a Swoop/Flare.

Resolution:

Use the Troubleshooting Configurations to fine-tune for Swoop/
Image Removed

V-Groove Outside has a Swoop

Problem:

  • The Outside cut of the non-oval V-Groove has Swoops.

Image Removed

Resolution:

  • Decrease the Outside Rotation.

Info

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Image RemovedImage Removed

V-Groove Outside has a Flare

Problem:

  • The Outside cut of the non-oval V-Groove has Flare.

Image Removed

Resolution:

  • Increase the Outside Rotation value. 

Info

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Image RemovedImage Removed
Info
Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6

  • For Additional Information: See Troubleshooting Utility for information on adjusting for a Swoop or Flare in a Non-Oval V-Groove.

Image Removed
Image AddedImage AddedImage Added