Cartridges Involved
This Configuration element involves the following Cartridges.
Note: Not all cartridges are available for all CMC models.
Rotation on V-Grooves Definition
Outside Rotation |
|---|
on |
|---|
V-Grooves |
|---|
|
|
The first cut is the interior V-Groove line and cut into the V-Groove fallout and not the matboard, and is cut in a clockwise direction. This uses the Inside Rotation.
See Also: V-Groove Inside Rotation
Problem:
The Inside Cut of the non-oval V-Groove cuts with a Swoop/Flare.
Resolution:
Edit the Inside Rotation (V-Groove).
See Also: Troubleshooting Utility for Non-Oval V-Grooves
Problem:
The Non-Oval V-Groove cuts with a Swoop/Flare.
Resolution:
Use the Troubleshooting Configurations to fine-tune for Swoop/Flare in a Non-Oval V-Groove.
|
V-Groove Outside has a Swoop
Problem:
The Outside cut of the non-oval V-Groove has Swoops.
Resolution:
Decrease the Outside Rotation. Adjust until the object cuts without a Swoop.
When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
V-Groove Outside has a Flare
Problem:
The Outside cut of the non-oval V-Groove has Flare.
Resolution:
Increase the Outside Rotation value. Adjust until the object cuts without a Swoop/Flare.
When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
|    |