...
Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Rotation on Outsides Definition
| Expand | ||
|---|---|---|
| ||
The Rotation controls for Swoops and Flares in non-oval objects. |
| Tip |
|---|
|
Current Bevel Type
Select the desired Cartridge Type Tab.
Select the desired bevel type from the Current Bevel Type dropdown control.
Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.
Outside has a Swoop
Problem:
The beginning of the cut swoops toward the Non-Oval Outside.
| Expand | ||
|---|---|---|
| ||
The Rotation controls for Swoops and Flares in non-oval objects. |
Resolution:
Increase the Rotation.
Outside has a Flare
Problem:
The beginning of the cut flares away from the Non-Oval Outside.
| Expand | ||
|---|---|---|
| ||
The Rotation controls for Swoops and Flares in non-oval objects. |
Resolution:
Decrease the Rotation.
Twisted Corner
Problem:
A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.
This is especially visible from the back of the mat.
| Expand | ||
|---|---|---|
| ||
The Rotation controls for Swoops and Flares in non-oval objects. |
Resolution:
Check to make sure the Rotation hasn't been set to a high number.
Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.
Check the Air Regulator for excess water.
Use the Clean the Foot Block procedure for cleaning the foot block.
Rotation on the Outsides | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Contents:
|   | |||||||||||||||||||||||||||||||||||||||||||||||||||