Content Comparison

Align the Head Button on the CMC Z (9000z)

Click the Align the Head button to Align the Head into the cutting position and power up the motors in preparation of cutting a mat.

Info
Aligning the Head will get the machine ready to cut, but not actually cut. You will need to click the Cut Button to cut the design.

Info
NOTE: The hardware photos below may slightly differ from your specific model but the steps are still the same.

Optionally, if you click the Cut button when the motors are disengaged, it will prompt you to Align the Head.
After the Head is Aligned, itwill then Cut the mat.

...