Page Comparison

The Interior Backup is where the blade backs up before initially plunging into the fallout of the opening, such as when cutting a French Stair. 

Interior Cuts cut into the fallout of the opening, not the matboard. 

Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.

• Normal Bevel

• Reverse Bevel

• Normal Bevel-Front of Mat

• Reverse Bevel-Front of Mat

The Interior Backup is displayed on the Configuration Map and on the associated field as a black arrow. 

Check against the Configuration Map of the Bevel Type you are cutting to determine specifically which cuts are the Interior Backups.

Interior Cuts, such as on French Stairs, cut into the fallout of the opening, not the matboard. 

This is viewed from the front of the mat. If the Interior Backup plunges the blade too soon, it makes the interior backup too long.

Decrease the Interior Backup.

The corners will now

meet up properly.

When making adjustments, click either the minus or plus

button (-/+) at the end of the desired field about five or six times in the direction indicated. Click

OK and do

a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

This is viewed from the front of the mat. If the Interior Backup plunges the blade too late, it makes the interior backup too short.

Increase the Interior Backup.

The corners will now

meet up properly.

When making adjustments, click either the minus or plus

button (-/+) at the end of the desired field about five or six times in the direction indicated. Click

OK and do

a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

This is viewed from the front of the mat. For Backups where the blade plunges into the matboard instead of the fallout, see Exterior Backup.