Page Comparison

The 90 Degree Cartridge cuts into the matboard at 90° and leaves no bevel. 

Select the desired Bevel Type from the Current Bevel Type dropdown control.

Below is a list of support documentation for editing the configurations of the 90 Degree Bevel Cartridge on the 90 Degree Tab.

Select this topic to see information on editing the configurations for the 90 Degree Opening, including:

• Normal Bevel

• Normal Bevel-Front of Mat

Select this topic to see information on editing the configurations for the 90 Degree Drop, including:

• Normal Drop

• Normal Drop-Front of Mat

Select this topic to see information on editing the configurations for the 90 Degree Outside, including:

• Outside

• Outside-Front of Mat

Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview.