Versions Compared

Version Old Version 20 New Version Current
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Troubleshooting the Backup/Overcut Display: Cut Preview

  • Have a cut

design

  • design displayed on the Cut Preview.

This

  • Note that this feature is only available for the

bladed cartridges

  • Bladed Cartridges.

  • Using one of the

zoom

  • Zoombuttons, zoom in to the desired section of the project where you are having issues cutting.

Image Removed

Image Added

  • Make sure that the Green Backups and Red Overcuts lines are visible.

Expandtitletitle

Insert excerpt
Exterior Backup Definition
Exterior Backup Definition

The Exterior Backup controls where the blade plunges into the matboard on the exterior cut. 

Expand

nameExterior Backup Definition
Insert excerpt
Interior Backup Definition
Interior Backup Definition
nameInterior Backup Definition
Insert excerpt
Exterior Overcut Definition

The 

Exterior Overcut

 controls where the blade retracts from the matboard on the exterior cuts.
Expand
titleInterior Backup Definition

The Interior Backup controls where the blade plunges into the fallout on interior cuts.

Expand
titleInterior Overcut Definition

The Interior Overcut controls where the blade retracts from the fallout on interior cuts.

Image Removed

Definition
nameExterior Overcut Definition
Insert excerpt
Interior Overcut Definition
Interior Overcut Definition
nameInterior Overcut Definition

Image Added

  • With the cursor hovering over one of the Backups or Overcuts, the

status bar

  • Status Bar displays the actual physical length of the selected Backup or Overcut.

  • This value will be the

sum

  • Sum of the corresponding

user configuration

  • User Configuration setting and the

factory configuration

  • Factory Configuration setting.

Image Removed
Image Added

  • The cursor will turn into an arrow with a question mark.

  • Click on the desired

overcut

  • Overcut or

backup

  • Backup line that you are having trouble with

.
Expand
titleExterior Backup Definition

The Exterior Backup controls where the blade plunges into the matboard on the exterior cut. 

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on the exterior cuts.

Expand
titleInterior Backup Definition

The Interior Backup controls where the blade plunges into the fallout on interior cuts.

Expand
titleInterior Overcut Definition
The Interior Overcut controls where the blade retracts from the fallout on interior cuts
Image Removed
Image Added

  • The Configuration screen will open to the appropriate Cartridge Tab

is selected and

  • with the Configuration Field associated to the line clicked

on will be

  • highlighted.

  • Now you can easily

increase or decrease

  • adjust the value displayed, depending upon whether the item

selecting

  • selected is cutting

too long or cutting too short

  • Too Short or cutting Too Long.

    • Increase the value if the item is cutting Too Short.

    • Decrease the value if the item is cutting Too Long.

  • Click OK and recut the design

,

  • .

  • Continue adjusting the Configurations until you achieve the desired result.

Tip

  • To adjust, click

plus

  • Plus/

minus

  • Minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Image RemovedIt will open the Configurations screen with the Cartridge selected and the specific Backup or Overcut field selected.
Image Added