Versions Compared

Version Old Version 18 New Version Current
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-plus
panelIcon:plus:
panelIconText:plus:
bgColor#FFFAE6

  • The Line tool in Trace will draw a Two-Point Line : in Trace.

    • Initial Position (called an Anchor)

    • Terminating Position (called an Anchor)

  • After it is drawn, a Center point will be displayed, which can be moved to alter the line into an Arc.

  • When drawing:

    • Left-Click sets the Point under the Cursor.

    • Right-Click Snapsto the nearest Point.

    • Hold down the CTRL key to draw in Ortho Mode; i.e., Horizontally/Vertically only.

  • After it is drawn, a Center point will be displayed, which can be moved to alter the line into an Arc.

Excerpt
hiddentrue
nameLine Tool Definition

  • The Line tool in Trace will draw a Two-Point Line : 

    • Initial Position (called an Anchor)

    • Terminating Position (called an Anchor)

  • After it is drawn, a Center point will be displayed, which can be moved to alter the line into an Arc.

  • When drawing:

  • Left-Click sets the Point under the Cursor.

    • Right-Click Snapsto the nearest Point.Hold down the CTRL key to draw in Ortho Mode; i.e., Horizontally/Vertically only.

    in Trace.