Line Design Details | ||||||
|---|---|---|---|---|---|---|
| Panel | ||||||
| panelIconId | atlassian-note | panelIcon | :note:||||
| bgColor | #B3F5FF | |||||
| Insert excerpt |
|---|
| panelIconId | atlassian-info |
|---|---|
| panelIcon | :info: |
| bgColor | #B3F5FF |
|
The Line tool in Trace will draw a Two-Point Line.
The Line is defined by two points: the Initial Position and the Terminating Position (which are called “anchors”).
After it is drawn, a third point in the Center is displayed, which can be moved to alter the Line into an Arc.
|
| Info |
|---|
|
Design Line Details | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Start X and Start Ypanel | ||||||||||||||||||||
| ||||||||||||||||||||
| Expand | ||||||||||||||||||||
| Insert excerpt | ||
|---|---|---|
|
|
| Expand | ||
|---|---|---|
| ||
The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. |
|
Mid X and Mid Y
| Info | |
|---|---|
| panelIcon | :info: | bgColor | #B3F5FF
|
| Expand | ||
|---|---|---|
| ||
The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. |
| Expand | ||
|---|---|---|
| ||
The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. |
End X and End Y
panel| panelIconId | atlassian-|
|---|---|
| Info | |
| :info: | |
| bgColor | #B3F5FF |
|
| Expand | ||
|---|---|---|
| ||
The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. |
| Expand | ||
|---|---|---|
| ||
The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. |
Angle
| panelIconId | atlassian-info |
|---|---|
| panelIcon | :info: |
| bgColor | #B3F5FF |
Angle
This displays the Angle, in degrees, of the Line.
The Angle is the space, in degrees, between a given line and an unseen horizontal line intersecting its end point.
Length
Displays the Length of the Line in the current dimensions.
Bevel Type
Displays the Bevel Type if the current line is Traced.
| Insert excerpt |
|---|
Layer
| panelIconId | atlassian-info |
|---|---|
| panelIcon | :info: |
| bgColor | #B3F5FF |
|
The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.
| Expand | ||
|---|---|---|
| ||
Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC. The Set Bevels Tab in Trace contains the tools needed to Trace the design. |
|
Layer
Displays the Layer numberthis line is assigned to if it is Traced.
| Expand | ||
|---|---|---|
| ||
Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC. The Set Bevels Tab in Trace contains the tools needed to Trace the design. |
| Insert excerpt | ||||||
|---|---|---|---|---|---|---|
|
Related Links |
|---|