Cartridges Involved
This Configuration element involves the following Cartridges.
Note: Not all cartridges are available for all CMC models.
Increase the Outside Rotation value.
When making adjustments, click the plus button (+) at the end of the desired field about five or six times.
Click OK and do a test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The object will now cut correctly.
See Also: V-Groove Inside Rotation
Problem:
The Inside Cut of the V-Groove cuts with a Swoop/Flare.
Resolution:
Edit the Inside Rotation (V-Groove).
Outside Rotation on V-Grooves |
|---|
The Rotation field controls how much the foot block will rotate before cutting. Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing.
The first cut is the interior V-Groove line.
The second cut is the exterior V-Groove line.
Problem: V-Groove Outside has a Swoop
Problem:
The Outside V-Groove cuts with a Swoop.
Resolution:
Decrease the Outside Rotation.
When making adjustments, click the minus button (-) at the end of the desired field about five or six times.
Click OK and do a test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The object will now cut correctly.
Problem: V-Groove Outside has a Flare
Problem:
The Outside V-Groove cuts with a Flare.
Resolution:
|    |