Cartridges Involved
This Configuration element involves the following Cartridges.
Note: Not all cartridges are available for all CMC models.
Oval Rotation Definition
Current Bevel Type
Select the desired Cartridge Type Tab.
Select the desired bevel type from the Current Bevel Type dropdown control.
Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.
Oval Opening has a Bump
Problem:
The opening is cut with a bump in the oval.
Resolution:
Increase the Oval Rotation. Adjust until the object cuts without a Bump.
When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
Oval Opening has a Feather
Problem:
The opening is cut with a feather in the oval.
Resolution:
Decrease the Oval Rotation. Adjust until the object cuts without a Feather.
When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
Circle/Oval Rotation Utility
Problem:
The Circle/Oval cuts with a Feather/Bump.
Resolution:
Use the Circle/Oval Rotation Utility to fine-tune specific sizes of circles/ovals.
Oval Rotation on Openings | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Contents:
|   | |||||||||||||||||||||||||||||||||||||||||||||||||||