Content Comparison

Have a cut

design displayed on the Cut Preview.

Note that this feature is only available for the

Bladed Cartridges.

Using one of the

Zoombuttons, zoom in to the desired section of the project where you are having issues cutting.

Make sure that the Green Backups

and Red Overcuts

lines

are visible.

With the cursor hovering over one of the Backups or Overcuts, the

Status Bar displays the actual physical length of the selected Backup or Overcut.

This value will be the

Sum of the corresponding

User Configuration setting and the

Factory Configuration setting.

The cursor will turn into an arrow with a question mark.

Click on the desired

Overcut or

Backup line that you are having trouble with.

• Exterior Backup

• Exterior Overcut

• Interior Backup

• Interior Overcut

The

Configuration screen will open to the appropriate Cartridge Tab

with the Configuration Field

associated to the line clicked

highlighted.

Now you can easily

adjust the value displayed, depending upon whether the item

selected is cutting

Too Short or cutting Too Long.

• Increase the value if the item is cutting Too Short.

• Decrease the value if the item is cutting Too Long.

Click OK and recut the design

.

Continue adjusting the Configurations until you achieve the desired result.