Versions Compared

Version Old Version 14 New Version Current
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
title

Line Design Details

  • Click on a Line to see the specific details about it. 

Expand
Insert excerpt
Line Tool Definition

The Line tool in Trace will draw a Two-Point Line. 

The Line is defined by two points: the Initial Position and the Terminating Position (which are called “anchors”).

After it is drawn, a third point in the Center is displayed, which can be moved to alter the Line into an Arc.

Image Removed

Line Tool Definition
nameLine Tool Definition

Image Added
Info

  • The Design Details section displays information about the selected line.

Image RemovedImage Added
title

Design Line Details

Start X and Start Y

info

  • Displays the Start X/Y Coordinates of the object’s start point when drawn.

    • If you clicked on the upper left and drew by dragging to the lower right, that would make the start point the upper left corner. 

Expand
Insert excerpt
X and Y Position

Definition 

The

X

Positionfield is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 
Expand
titleY Position Definition

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

Image Removed

and Y Position
nameX and Y Position Definition

Image Added

Mid X and Mid Y 

Info

  • The Middle Point X and Y Coordinates.

Expand
titleX Position Definition

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

Expand
titleY Position Definition

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

Image RemovedImage Added

End X and End Y 

Info

  • The End Point X and Y Coordinates.

Expand
titleX Position Definition

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

Expand
titleY Position Definition

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

Image Removed

Angle 

infoImage Added

Angle 

  • This displays the Angle, in degrees, of the Line.

  • The Angle is the space, in degrees, between a given line and an unseen horizontal line intersecting its end point. 

Image RemovedImage Added

Length 

info

  • Displays the Length of the Line in the current dimensions.

Image RemovedImage Added

Bevel Type 

Info
expand

Insert excerpt

title

Traced

Bevel Type Definition

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

Expand
titleTraced Definition

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

Image Removed

Layer 

Info

Traced
nameTraced Definition

Image Added

Layer 

Expand
titleTraced Definition

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

Image Removed

Insert excerpt
Layer Definition
Layer Definition
nameLayers Definition

Image Added