Page Comparison

Measuring Tape Properties

Use the Tape Measure Properties to edit the individual proprietary adjustments available for the Tape Measure.

Info
Click on the Measuring Tape and click on the Properties Tab.

Edit the individual proprietary adjustments available for the Measuring Tape.

Info

on

Measure and select Edit Tape Measure to open the

Image Removed

Tape Measure Points

Info
Point 1 and Point 2 are the two control points of the Tape Measure. These points are referenced from the bottom-left of the design, which is 0,0.

Point 1 - Tape Measure

Point 1 is the lower left point of

Info
The control point of the Measuring Tape will turn red when snapped to another object. The Measuring Tape will remain snapped to the object even if you move or resize the object.

Image Removed

Unsnapping the Measuring Tape From the Objects

To unsnap the Measuring Tape from an object, click on one of the lines of the Measuring Tape (not the corners) and drag it to the desired position.

Image Removed

to edit the individual proprietary adjustments available for the Tape Measure.

Point 2 - Tape Measure

Point 2 is the upper right point of the Tape Measure.

Image Removed

Tape Measure Sizes

Info
The Width is displayed on the horizontal line of the Measuring Tape. The Height is displayed on the vertical line of the Measuring Tape. The Distance is measured between Point 1 and Point 2 and displayed on the diagonal line

Image Removed

Click and drag the Measuring Tape control point to a control point of the desired object(side/corner) and let it snap.
Click and drag the other Measuring Tape control point to the next object and let it snap.
The measurements between each of the triangular points are displayed on the Measuring Tape.