Versions Compared

Version Old Version 12 New Version Current
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cut the Outside as a Shared Edge

  • Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts

on the CMC Z1 and Z (9000z).    Expand
titleShared Edge Definition
Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts

  • .  

  • The Shared Edge function will cut the Shared Edges of the Tiled Outside Cuts on the CMC Z1

and

  • , Z(9000z), 9000 and 8000+ as one stroke between the designs, instead of cutting the outside of each mat individually.

   

  •  

Image Removed
Image Added
zero

  • Zero (0) so that each design shares the

outside

  • Outside lines with the next design, so it will only cut the single line between them. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Image Removed

Advanced Outside Options

Info
Image Removed
Image Removed

  • The shared outside edges of the tiled design will cut in one stroke. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Image Removed

Defaults: Set the Default for Cutting the Outside 

Expand
titleDefault Setting for Cutting the Outside

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Image Removed

Defaults: Set the Default for 90 Degree Outside Cut

Expand
titleDefault Setting for 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Image Removed

Defaults: Set the Default for the Advanced Options

Expand
titleDefault Setting for the Default Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Image Removed

Defaults: Set the Default for the Cut Mode

Expand
titleDefault Setting for Default Cut Mode

The default setting for the Cut Mode can be set in the Admin > Cutting section.

Image Removed

    • Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Image Added

Default Settings