Page Comparison

Load the CutArt into the Design editor.

Click on the Properties tab.

Enter 30* in the Rotation field.

The CutArt is rotated 30°. 

Note that this does not alter the original CutArt, only the copy that is currently loaded into the screen.

To rotate the actual CutArt, see Trace Lesson Eleven: Rotate Starburst within Trace.

*See Determining the Degree of Rotation Rotation for information on how to determine the optimum degree of rotation for your particular CutArt.

Cut the CutArt.

The starburst design is completed.

Since it is a Deboss design, you can also size it much smaller if desired without worrying about overcuts and backups.