Design in FrameShop then bring into Trace | |
|---|---|
This lesson shows how to combine a CutArt into the corners of a design to make fancy corners with a fancy V-Groove around it. Place a 8x10" #101 Rectangle template on the FrameShop editor. Right-Click on the opening and select New Guide from Other. |  |
On the Add Other Guide screen, click the checkboxes for Add at Top and Add at Left . Enter 3/4" for each value. Click the OK button. The guides are placed. |  |
Add CutArt | |
|---|---|
 | |
On the Browse Content screen, select the desired CutArt and click the Select button. |  |
Click on the Properties tab. Change the CutArt size to 2x2" or to the desired size. |  |
Move the CutArt to the upper left corner and snap it to the two guide lines we placed earlier. |  |
Bring Design into Trace | |
|---|---|
Bring the design into Trace via the Right-Click Menu* or from the Cut Preview Screen. *If you use the right-click method, hold down the CTRL key and select the opening and the CutArt before selecting Convert to CutArt. |  |
Draw Reference Lines | |
|---|---|
We will use these reference lines to mirror our corner design. Click on the Line button on the Trace and Draw tab. Right-Click on the center point of the top outside line. Right-Click on the center point of the bottom outside line. The vertical reference line is drawn. Right-Click on the center point of the left outside line. Right-Click on the center point of the right outside line. The horizontal reference line is drawn. | |
...