...
Red Arrow on the Configuration Map | |
|---|---|
The Exterior Overcut is displayed on the Configuration Map as a red arrow. |  |
Check against the Configuration Map of the Bevel Type you are cutting to determine specifically which cuts are the Exterior Overcuts. Exterior Cuts, such as rectangles, cut into the matboard, not the fallout of the opening. |  |
Outside Exterior Overcut TooShortLong | |
|---|---|
This is viewed from the front of the mat. If the the Exterior Overcut Overcut retracts the blade the blade too soonlate, it makes the exterior overcut too shortlong. |   |
Increase Decrease the Exterior Overcut. |  |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  |
Outside Exterior Overcut TooLongShort | |
|---|---|
This is viewed from the front of the mat. If the the Exterior OvercutOvercut retracts the blade the blade too latesoon, it makes the exterior overcut too longshort. | |
Decrease Increase the Exterior Overcut. | |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
...