Horizontal Home for Openings | |
|---|---|
The Horizontal Home defines home defines the global horizontal placement of objects cut with the blade cartridges. |  |
Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big | ||
|---|---|---|
Adjust the Horizontal Home if home if the opening is cutting too far to the right (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | ||
The opening is cutting too far to the right. |  | |
Decrease the Horizontal Home home. |  | The opening will now cut in the correct place. |
 When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  | |
Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small | ||
|---|---|---|
Adjust the Horizontal Home if home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | ||
The opening is cutting too far to the left. |  | |
Increase the Horizontal Home home. |  | The opening will now cut in the correct place. |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | | |
Horizontal Home Troubleshooting | |
|---|---|
Alternatively, adjust the Horizontal Home on home on the Troubleshooting Screen. |  |
...