...
Current Outside Bevel Type | |
|---|---|
Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.
|   |
Red Arrow on the Configuration Map | |
|---|---|
The Exterior Overcut is displayed on the Configuration Map as a red arrow. |   |
Check against the Configuration Map of the Bevel Type you are cutting to determine specifically which cuts are the Exterior Overcuts. |   |
Exterior Cuts, such as rectangles, cut into the matboard, not the fallout of the opening. |  |
Outside Exterior Overcut Too Short | |
|---|---|
If the Exterior Overcut retracts the blade too soon, it makes the exterior overcut too short. |   |
Increase the Exterior Overcut. |   |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  |
Outside Exterior Overcut Too Long | |
|---|---|
If the Exterior Overcut retracts the blade too late, it makes the exterior overcut too long. |   |
Decrease the Exterior Overcut. | |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
...