Opening Adjustment for Crease | |
|---|---|
Adjust the Opening Adjustment if the Crease is applied at the wrong size. |   |
Current Bevel Type | |
|---|---|
Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. The Crease is automatically applied from the front of the mat, so you do not need to select Crease-Front of Mat.
|   |
Crease Size too Small | |
|---|---|
The Crease is applied too small. |   |
Increase the Crease Opening Adjustment. |   |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |   |
Crease Size too Big | |
|---|---|
The Crease is applied too big. |   |
Decrease the Crease Opening Adjustment. | |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Opening Adjustment in the Troubleshooting Screen | |
|---|---|
Alternatively, adjust the Opening Adjustment in the Troubleshooting Screen by entering the measured height and width of the tool line into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only the Crease is present on the screen, otherwise the Troubleshooting Button will be grayed out. |  |