...
Crease is Applied too Small | |
|---|---|
The Crease is applied too small. |   |
Increase the Crease Opening Adjustment.  |  |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  |
Crease is Applied too Big | |
|---|---|
The Crease is applied too big. |   |
Decrease the Crease Opening Adjustment. | |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Opening Adjustment in the Troubleshooting Screen | |
|---|---|
Alternatively, adjust the Opening Adjustment in the Troubleshooting Screen by entering the measured height and width of the tool line into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only the Crease is present on the screen, otherwise the Troubleshooting Button will be grayed out. |  |