...
Red Arrow on the Configuration Map | |
|---|---|
The Exterior Overcut is displayed on the Configuration Map as a red arrow. |  |
Check against the Configuration Map of the Bevel Type you are cutting to determine specifically which cuts are the Exterior Overcuts. |   |
Exterior Cuts, such as rectangles, cut into the matboard, not the fallout of the opening. |  |
Outside Exterior Overcut Too Short | |
|---|---|
If the Exterior Overcut retracts the blade too soon, it makes the exterior overcut too short. |   |
Increase the Exterior Overcut. |   |
Outside Exterior Overcut Too Long | |
|---|---|
If the Exterior Overcut retracts the blade too late, it makes the exterior overcut too long. |   |
Decrease the Exterior Overcut. | |
Outside Interior Overcuts | |
|---|---|
For Overcuts where the blade comes out of the fallout instead of the matboard, see Interior Overcut. |   |