Page Comparison

Select the desired Cartridge Type Tab on the Configurations screen.

Click the Circle/Oval Rotation button.

Select the Bevel Type Cutting Direction for the bevel type you are editing from the upper left dropdown control.

See Bevel Type Cutting Direction for information on the cutting direction for the different bevel types.

Put in an 11x12" mat into the CMC and click Cut.

Align the Head if necessary.

After it cuts, check the cuts and determine if you are getting a Bump or a Feather for any of the oval sizes that were cut.

A Bump is A Bump forms when the blade returns to the outside the outside of the starting point , thus creating a bump in the circle because the because the Oval Rotation is  is too low. Increase the Oval Rotation.

A Bump displays on the circle where the blade returns to the outside of the starting point.

Selecting Select the desired oval size listing , and increase the Oval Rotation value by moving the slidebar of the oval size to the right.

This is like increasing the Oval Rotation field on the Configurations screen,but is specific to this particular oval size.

Do another test cut. Keep making adjustments until the ovals cut out as expected.