Remnant Trimming |
---|
Select the desired remnant trimming direction on the CMC 9000z and Z1 Z1 and Z (9000z) from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use. |
...
Remnant Trimming: VerticalSet Remnant Trimming to Vertical to set the default to cut the remnant matboard off vertically. | |
---|---|
Click Set Advanced Options to access the Advanced Outside Cut Options. Set Remnant Trimming to Vertical. | |
The design will cut and trim off the remnant matboard vertically. |
Set the Default for Cutting the Outside | |
---|---|
The default setting for Cutting the Outside can be set in the Admin > Editor section. |
Set the Default for 90 Degree Outside Cut | |
---|---|
The default setting for 90 Degree Outside can be set in the Admin > Cutting section. |
Set the Default for the Advanced Options | |
---|---|
The default setting for the Advanced Options can be set in the Admin > Cutting section. |
Set the Default for Remnant Trimming | |
---|---|
The default setting for the Remnant Trimming can be set in the Admin > Cutting section. |