Cut the Outside Toggle |
|---|
Use the Cut the Outside toggle to select cutting or not cutting the outside of the mat. |
...
Set Advanced Options: Enable Outside Cut | |
|---|---|
Select Optionally, select this topic to see information on Enabling Outside Cut on the Advanced Outside Options. |  |
Set the Default for Cutting the Outside | |
|---|---|
The default setting for Cutting the Outside can be set in the Admin > Editor section. |  |
Set the Default for 90 Degree Outside Cut | |
|---|---|
The default setting for 90 Degree Outside can be set in the Admin > Cutting section. Note that the CMC 8000 cannot support cutting with the 90 Degree Outside. |  |
...
Disable Auto Clamp OffsetDisabling the Auto Clamp Offset will cut the design normally without being offset into the mat on the CMC 9000z and Z1. | |
|---|---|
Uncheck the Auto Clamp Offset checkbox. The design will no longer be offset on the CMC 9000z and Z1 and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above. |  |
Set the Default for the Enable Auto Clamp Offset | |
|---|---|
The default setting for the Enable Auto Clamp Offset for the CMC 9000z and Z1 can be set in the Admin > Cutting section. |  |
...
Disable Rail DodgeDisabling the Rail Dodge will now cut the designs normally without being offset up and over on the mat. | |
|---|---|
Uncheck the Rail Dodge checkbox. The design will no longer be offset on the CMC 8000 and 9000 and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above |  |
Set the Default for the Rail Dodge | |
|---|---|
The default setting for the Rail Dodge can be set in the Admin > Cutting section. |  |