Content Comparison

The Shared Edge function cuts the Shared Edges of the Tiled Outside Cuts as a single stroke between the designs, rather than cutting the outside of each mat individually.

This feature is only for the CMC Z1, Z(9000z), 9000 and 8000+.

Make sure that the Spacing between the outsides is set to Zero (0).

NOTE: The Outside cut direction and cut order will differ from cutting Full when cutting using Shared Edge.

• Keep this in mind when adjusting the Backups and Overcuts on the Configurations.

• See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting the Backups and Overcuts displayed on the Cut Preview.