Page Comparison

Changing the 45 Degree Blade: CMC Z1, Z(9000z), 9000, 8500eSBT, 8500e, 8500, 8000, 8000RC and 8000+

Info

The 45° metal black blade cartridgeCartridge* is designed to cut 45° bevels on standard 4-ply matboard.
The 45° metal black blade cartridgeCartridge is labeled 45° on the end.
Notes:
- Your hardware may look different than the model pictured, but the process is still the same.
- The 45° blade cartridge Cartridge does not support blade depths above 16.
  - *Older systems may have a 45° plastic black blade cartridgeCartridge.

Push the blade cartridge Cartridge release down to eject the blade cartridgeCartridge.

The blade cartridge Cartridge displays a diagram of the blade orientation (shown in contrast).
Place new blade into cartridge Cartridge with the longest side to the right and the bevel face down, lining up the bottom hole of the blade over the pin in the cartridgeCartridge.
The blade should fit snugly into the recess space provided for it.

Info
NOTE: If there is any side-to-side movement of the blade in the blade cartridgeCartridge, it is time to replace the blade cartridgeCartridge.

Insert the blade cartridge Cartridge into the Head with the blade facing toward the board and the notch on the back of the cartridge Cartridge facing the Head.
It should click into place.
- It can only be inserted one way.