Page Comparison

The X Position field is used to set or display the Horizontal position of the selected object in the Design Editor, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in the Design Editor, Trace and the Cut Preview. 

The Curve function allows you to draw a four-point mathematically defined Bezier/Spline Curve in the Trace software.

The Bezier/Spline Curve is defined by four points: Initial Position (called an Anchor), Two Separate Middle Points (called Handles) which can be moved to alter the shape, and the Terminating Position (called an Anchor)

The Convert Arc to Splines process will convert any Arcs to Splines/Curves which are easier to tangify to make cuts smoother.

See: Arc Definition

See: Arcs Tool Function

See: Splines Definition

See: Splines Tool Function

See: Convert Arc to Splines Function

• Displays the first Mid Point X1 and Y1 Coordinates.

The X Position field is used to set or display the Horizontal position of the selected object in the Design Editor, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in the Design Editor, Trace and the Cut Preview. 

• Displays the second Mid Point X2 and Y2 Coordinates.

The X Position field is used to set or display the Horizontal position of the selected object in the Design Editor, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in the Design Editor, Trace and the Cut Preview. 

• Displays the End Points X and Y Coordinates.

The X Position field is used to set or display the Horizontal position of the selected object in the Design Editor, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in the Design Editor, Trace and the Cut Preview. 

• Displays the Bevel Type if the current object is Traced.

• For Additional Information: See Bevels and Cartridge Types for information on Bevels and Cartridge Types that can be Traced.

• Displays the Layer this object is assigned to if the object is Traced.

• For Additional Information: See the Layers section in the Set Bevels Tab.

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply with a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

See: Tracing the Design