Page Comparison

The Interior Overcut for V-Grooves controls where the Blade Retracts from the Fallout (not the Matboard) on the Interior cuts of the Inside Cut of the V-Groove.

The Interior Cut is where the Blade Plunges/Retracts from the Fallout (not the Matboard).

• If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Long, Decreasethe Interior Overcut on V-Grooves.

• If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Short, Increase the Interior Overcut on V-Grooves.