Versions Compared

Old Version 3

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 4

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Enable Auto Offset: Location Tab

Info

  • Select Auto Offset checkbox to move the design up and over on the matboard to avoid the Clamp area on the Cut Preview.

Tip

  • Click on the design to select it.

  • Check the Auto Offset checkbox.  

  • Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value. 

  • It will move the lower left corner of the design to the new X/Y Position and it will display Dodge on the bottom of the screen.

  • This feature is also turned on by selecting Full from the Outside Cut Options dropdown control.

Expand
titleAuto Offset Definition

The Auto Offset moves the design up and over on the Cut Preview to avoid the Clamparea.

This is to overcome the Border Limitation of 1.25"/3.2 cm on the Cut Preview.

See: Auto Offset Setting

See: Auto Offset Definition

See: Auto Offset Default Setting