Page Comparison

• Select whether to default to Cutting the Outside of the mat.

• For Additional Information:

• See Matboard Properties in the Design to turn on/off the Outside cut.

• Select Options Menu > Cut Outside on the Cut Previewto cut the outside of the mat.

• See /wiki/spaces/FrameShop8x/pages/1942506497 on the Cut Previewto turn on/off the Outside cut.

• See Enable Outside Cutunder Advanced Outside Options on the Cut Previewto toggle on/off the Outside cut.

• See Cut Outside Using 90 Degree Tool under Set Advanced Optionson the Cut Preview.

• See Cut Mode in the Set Advanced Options section on the Cut Preview.

• See Remnant Trimming in the Set Advanced Options section on the Cut Preview.

The Outside Bevel is created by cutting into the fallout surface with the blade angled at 45°/52°, thereby slanting the bevel under the fallout surface. The matboard core is not visible from the front.

The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut.

Select Outside or Outside-Front of Mat from the Current Bevel Type dropdown control to edit this configuration.

See: 45 Degree Outside Configurations

See: 45 Degree Plus Outside Configurations

See: 45 Degree Front Outside Configurations

See: 52 Degree Outside Configurations

See: 90 Degree Outside Configurations