changes.mady.by.user dani.simmonds
Saved on May 13, 2024
Saved on Jun 26, 2024
...
First we need to make sure we are designing the layers in the correct order for these instructions.
On the FrameShop Main Page, click Admin and stay on the Defaults tab.
Under Layer Direction select Bottom Up if it is not already set to that.
Click Save and return to the Main Page.
You can change this back to the original setting later if desired.
Layer Direction: Bottom Up is the preferred direction.
When you Offset an object to create another layer, that new layer will be the Top layer.
Layer Direction: Top Down is not recommended.
When you Offset an object to create another layer, that new layer will be the Bottom layer, even though it is larger than the original object.
Place an 8.75 x 11.75” #102 Oval Template with two Layers on the FrameShop Design Editor.
Bring in two small ovals that are 3x5.
Edit the small ovals and make them four layers.
Width of the Inner Reveal is how much of the Inner Mat shows (i.e., .25).
Width of the Middle Reveal is the width of the Bridge between the two objects (i.e., .5).
Outer Reveal is the Inner Mat of the Bridge on the large object side (i.e., .25).
