Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Overshoot Definition

Panel
panelIconIdatlassian-plus
panelIcon:plus:
panelIconText:plus:
bgColor#FFFAE6
  • The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool(Deboss, Pen or Vinyl).

    • If the Overshoot is applied Too Long, Decrease the Overshoot.

    • If the Overshoot is applied Too Short, Increase the Overshoot.

Expand
titleOvershoot General Definition

The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool(Deboss, Pen or Vinyl).

If the Overshoot is applied Too Long, Decrease the Overshoot.

If the Overshoot is applied Too Short, Increase the Overshoot.

Expand
titleOvershoot General Definition

This is similar to the Overcut used with the Blade cartridges.

Image RemovedImage Added

See: Overshoot for Deboss Configurations

See: Overshoot for Pen Configurations

See: Overshoot for Vinyl Configurations

Expand
titleDeboss Overshoot Definition

The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool(Deboss, Pen or Vinyl).

If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.

If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot.

This is similar to the Overcut used with the Blade cartridges.

Image RemovedImage Added

See: Overshoot for Deboss Configurations

Expand
titlePen Overshoot Definition

The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool(Deboss, Pen or Vinyl).

If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.

If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot.

This is similar to the Overcut used with the Blade cartridges.

Image RemovedImage Added

See: Overshoot for Pen Configurations

Expand
titleVinyl Overshoot Definition

The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool(Deboss, Pen or Vinyl).

If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.

If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot.

This is similar to the Overcut used with the Blade cartridges.

Image RemovedImage Added

See: Overshoot for Vinyl Configurations

Expand
titleHow to Adjust the Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Image Removed
Image Added