...
Current Bevel Type | |
|---|---|
Make sure to select the desired Cartridge Tab Tab and then the outside bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. Select Front of Mat if it is being cut from the front of the mat. |  |
Red Arrow | |
|---|---|
The Exterior Overcut is displayed on the Configuration Map as a red arrow. |  |
Configuration Map | |
|---|---|
Check against the Configuration Map of the Bevel Bevel Type you are cutting to determine specifically which cuts are the Exterior Overcuts. |  |
Exterior Cuts, such as rectangles, cut into the matboard, not the fallout. |  |
Outside Exterior Overcut Too Short | ||
|---|---|---|
If the | exterior overcut retracts the blade too soon, it makes the exterior overcut too short.If the exterior overcut Exterior Overcut retracts the blade too soon, it makes the exterior overcut too short. |  |
Increase the Exterior Overcut. |  | |
Outside Exterior Overcut Too Long | ||
|---|---|---|
If | the exterior overcut retracts the blade too late, it makes the exterior overcut too long.If the exterior overcut the Exterior Overcut retracts the blade too late, it makes the exterior overcut too long. |  |
Decrease the Exterior Overcut. | | |
Outside Interior Overcuts | |
|---|---|
For Overcuts where the blade comes out of the fallout instead of the matboard, see Interior Overcut. |  |