changes.mady.by.user dani.simmonds
Saved on May 14, 2024
...
The Non-Blade Tool Tears the Corners, Increase the Corner Pause.
The Non-Blade Tool is pausing too long in the Corners, Decrease the Corner Pause.
For Additional Information: See Corner Pause for information on adjusting the Pause of the Non-Blade Tool in the corners.
The Corner Pause setting in Configurations is the amount of time, in milliseconds, to pause the application of the Non-Blade Tools between segments.
See: Corner Pause for Deboss
If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.
For Additional Information: See Overshoot for information on adjusting the Overshoot of the Non-Blade Tool in the corners.
The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool(Deboss, Pen or Vinyl).
If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot.
This is similar to the Overcut used with the Blade cartridges.
See: Overshoot for Deboss.
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
