Versions Compared

Version Old Version 24 New Version 25
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cut the Outside as a Shared Edge

  • Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts.   

Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6
Tip
Expand
titleShared Edge Definition

The Shared Edge function will cut the Shared Edges of the Tiled Outside Cuts on the CMC Z1, Z(9000z), 9000 and 8000+ as one stroke between the designs, instead of cutting the outside of each mat individually.

See: Shared Edge Cut Mode Function

  • When Tiling, make sure that the Spacing under the Setup Tab is set to Zero (0) so that each design shares the Outside lines with the next design, so it will only cut the single line between them. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Expand
titleRemnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

See: Remnant Trimming Function

Advanced Outside Options

Info
Tip
Image Removed
Image Removed

  • The Shared Outside edges of the Tiled design will cut in one stroke. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6
Tip

  • Default Settings: See Admin > Cutting for the default settings for Remnant Trimming.

Expand
titleRemnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Image Removed

See: Remnant Trimming Function

Image Removed