Page Comparison

Plunge Count On

Info
Use the Plunge Count toggle to automatically pause for a Blade Change after the specified Number of Blade Plunges entered on the Configurations screen. You may have to set the Cut Preview Screen to full screen to view this toggle.

Click the Plunge Count toggle On.
The system will pause for a Blade Change after the specified Number of Blade Plunges.

Panel

Info
NOTE: You may have to set the Cut Preview Screen to full screen to view this toggle.

Click the Plunge Count toggle On.

The system will pause for a Blade Change after the specified Number of Blade Plunges

See Options > Enable Plunge Counts to toggle on the Plunge Count on the Cut Preview menu.

Expand

title	Plunge Count Definition

The Plunge Count controls the number of Blade Plunges for each Blade Cartridge before pausing for a Blade Change.

If it doesn’t prompt for a Blade Change during the cut, enter the Plunge Count value and select Plunge Count on the Cut Preview.

If you don’t want it to prompt for a Blade Change during the cut, unselect Plunge Count on the Cut Preview.

See: Plunge Count Function

See: Plunge Count Value Configurations

Info
The Plunge Count value is set on the Configurations screen for each Blade Cartridge Tab.

Go to the Configurations screen.
Select the desired Blade Cartridge tab.
Enter the desired Plunge Count value for that Blade Cartridge in the Plunge Count field.
Click OK.
When the Blade Cartridge hits the selected Number of Blade Plunges while cutting, it will Pause for a Blade Change.

Panel

For Additional Information:
See Set Number of Blade Plunges in the Configurations screen.
See Options > Enable Plunge Counts to toggle on the Plunge Count on the Cut Preview menu.

Info
After the Number of Plunges entered in the Plunge Count field, the system will pause and Prompt for a Blade Change.

Cut the mats.
After the number of Plunges entered for this Blade Cartridge, the system will pause and Prompt for a Blade Change.
Change the Blade.
Click Continue.
It will continue to pause for a Blade change when the number of plunges have been met.

...