changes.mady.by.user dani.simmonds
Saved on Apr 25, 2024
...
If the Overcut is Too Long, Decrease the Overcut.
For Additional Information: See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting.
The Overcut controls where
the cartridgeRetracts from the Matboard
.
The Exterior Cut is where the Blade Plunges or Retracts from the Matboard (not the Fallout).
If the Overcut is cut Too Long, Decrease the Overcut.
If the Overcut is cut Too Short, Increase the Overcut.
The Overcut field is marked with a Red Arrow on the Configuration screen and the Mapillustration.
See: Overcut for Creases Configurations
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
If the Overcut is Too Short, Increase the Overcut.