Opening Cuts too Far Right (Not Cutting the Outside) | ||||||||
|---|---|---|---|---|---|---|---|---|
| Panel | | |||||||
| ||||||||
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
|
| Expand | ||
|---|---|---|
| ||
The Horizontal Home defines the global Horizontalplacement of objects cut with the Blade Cartridges. If the Opening is cut Too Far Left Horizontally, Increase the Horizontal Home. If the Opening is cut Too Far Right Horizontally, Decrease the Horizontal Home. |
| Expand | ||
|---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |
Opening Cuts too Far Left (Not Cutting the Outside) | ||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Panel | ||||||||||||||||||||||
| panelIconId | atlassian-note | |||||||||||||||||||||
| panelIcon | :note: | bgColor | #B3F5FF||||||||||||||||||||
| ||||||||||||||||||||||
...