Page Comparison

Cut Pattern: Unidirectional

Info
Set Unidirectional from the Cut Pattern dropdown control to cut Tiled mats in One Direction only on the CMC Z1, Z(9000z), 9000 and 8000+. Click the Set Advanced Options button to access the Advanced Outside Options.

:man_mage:1f9d9-200d-2642-fe0f

Panel

Panel

panelIconId

1f9d9-200d-2642-fe0f

panelIcon

panelIconText

🧙‍♂️

bgColor

#FFFAE6

For Additional Information: See /wiki/spaces/FrameShop8x/pages/1942506497 to turn on/off the Outside cut.

Panel

panelIconId

panelIcon

:man_mage:

panelIconText

🧙‍♂️

bgColor

#FFFAE6

For Additional Information: See Advanced Outside Options: Enable Outside Cut to turn on/off the Outside cut for the CMC Z1, Z(9000z), 9000 and 8000+.

tip

Tip
Default Settings: See Admin > Editor for the default settings for Cutting the Outside.
Tip
Default Settings: See Admin > Cutting for the default settings for the Advanced Options.
Tip
Default Settings: See Admin > Cutting for the default settings for the Cut Mode. See Admin > Cutting for the default settings for Tiling 90 Degree Outside.
Default Settings: See Admin > Cutting for the default settings for the Cut Mode Tiling.
Tip
Default Settings: See Admin > Cutting for the default settings for 90 Degree Outside.size for the Spacing between designs.

Info
This will cut the Outside of Tiled mats in One Direction only. This is useful if you want the Outside cuts of the Tiled mats to be exactly the same size, as the sizes may be off by the thickness of the blade when it's cutting Bi-Directional (two different directions) when cutting the Outside.

Tip
Default Settings: See Admin > Cutting for the default settings for Tiling.

It will cut the Outsides of Tiled mats in a Unilateral fashion, moving the Head in only One Direction.

...