Remnant Trimming |
|---|
Select the desired remnant trimming direction on the CMC Z1 and 9000z from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use. |
...
Remnant Trimming: VerticalSet Remnant Trimming to Vertical to set the default to cut the remnant matboard off vertically. | |
|---|---|
Click Set Advanced Options to access the Advanced Outside Cut Options. Set Remnant Trimming to Vertical. |  |
The design will cut and trim off the remnant matboard vertically. |  |
Set the Default for Cutting the Outside | |
|---|---|
The default setting for Cutting the Outside can be set in the Admin > Editor section. |  |
Set the Default for 90 Degree Outside Cut | |
|---|---|
The default setting for 90 Degree Outside can be set in the Admin > Cutting section. |  |
Set the Default for the Advanced Options | |
|---|---|
The default setting for the Advanced Options can be set in the Admin > Cutting section. |  |
Set the Default for Remnant Trimming | |
|---|---|
The default setting for the Remnant Trimming can be set in the Admin > Cutting section. |  |