Page Comparison

The Line tool in Trace will draw a Two-Point Line. 

The Line is defined by two points: the Initial Position and the Terminating Position (which are called “anchors”).

After it is drawn, a third point in the Center is displayed, which can be moved to alter the Line into an Arc.

• The Design Details section displays information about the selected line.

• Displays the Start X/Y Coordinates of the object’s start point when drawn.

  • If you clicked on the upper left and drew by dragging to the lower right, that would make the start point the upper left corner. 

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

• The Middle Point X and Y Coordinates.

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

• The End Point X and Y Coordinates.

The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. 

• This displays the Angle, in degrees, of the Line.

• The Angle is the space, in degrees, between a given line and an unseen horizontal line intersecting its end point. 

• Displays the Length of the Line in the current dimensions.

• Displays the Bevel Type if the current line is Traced.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

• Displays the Layer numberthis line is assigned to if it is Traced.

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.