Page Comparison

• The Tool Configs on the Configurations Screen displays the global settings for the bevel cartridge tabs. 

• Opening cuts in the wrong place Horizontally.

• Opening is cut too far Left:

  • Increase the Horizontal Home.

• Opening is cut too far Right:

  • Decrease the Horizontal Home.

The Horizontal Home defines the global Horizontal placement of objects cut with the Blade Cartridges.

If the Opening is cut too far Left, Increase the Horizontal Home.

If the Opening is cut too far Right, Decrease the Horizontal Home.

• Opening is cut in the wrong place Vertically.

• Opening is cut too far Up:

  • Decrease the Vertical Home.

• Opening is cut too far Down:

  • Increase the Vertical Home.

The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges.

If the Object is cut too far Up, Decrease the Vertical Home.

If the Object is cut too far Down, Increase the Vertical Home.

• Opening is cut at the Wrong Depth when a SKU has been selected.

• Blade Depth is too Deep:

  • Decrease the Depth Bias.

• Blade Depth is too Shallow:

  • Increase the Depth Bias.

The Depth Bias is used to calculate the properBlade Depth when the SKUselected for the matboard contains the Matboard Thickness.

The formula is: [(Default Depth) - 10]

For example, if the normal Blade Depth for 4-ply is 11, then 11-10=1, so enter 1 for the Depth Bias.

• Opening does not Pause for a Blade Change while cutting.

1. Adjust the Plunge Count in the Configuration Screen.

2. Toggle the Plunge Count to On in the Cut Preview.

3. See Plunge Count for additional information.

The Plunge Count controls the number of Blade Plunges for each Blade Cartridge before pausing for a Blade Change.

• Circle/Oval has a Feather/Bump.

• Oval Opening has a Feather:

  • Decrease the Oval Rotation.

• Oval Opening has a Bump:

  • Increase theOval Rotation.

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Bump, Increase theOval Rotation.