Page Comparison

• Remove the CMC box marked “bottom” from the shipped package and unfold it onto a flat surface.

• An area of at least 8’ x 10’ is needed to assemble the box.

• Make sure that the printed side of the box is face-down, toward the floor.

• Pre-fold the sides of the box to make assembly easier.

• Carefully peel back the adhesive paper from one corner flap and affix the corner flap to the inside edge of the box side.

NOTE: Take care that the adhesive does not touch any other surface other than the inside edge of the box side. The adhesive could become contaminated or pull away from the box surface.

• Press the corner flap firmly into the inside edge of the box to make sure it has made strong contact.

• The corner is assembled.

• Repeat the Steps above on the other three corners.

• Repeat the Steps above on the CMC Box marked “Top”.

• Locate each of the foam corners.

• Note that the foam corners that attach to the top of the board are wider than the foam corners used for the bottom of the board.

• Fold and separate the middle top and middle bottom foam corners from each other.

• Attach the bottom left, middle and bottom right foam corners.

• Attach the wider top left, middle and top right foam corners.

• For the model 5000, remove the insert before placing over the motors on the board.