Versions Compared

Version Old Version 24 New Version 25
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

...

Crease Exterior Backup is too Long

Problem:

  • The Crease Exterior Backup is too Long.

Resolution:

Expand
titleExterior Backup Definition

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

Crease Exterior Backup is too Short

Problem:

  • The Crease Exterior Backup is too Short.

Resolution:

Expand
titleExterior Backup Definition

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

Crease Exterior Overcut is too Long

Problem:

  • The Crease Exterior Overcut is applied Too Long.

Resolution:

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

Crease Exterior Overcut is too Short

Problem:

  • The Crease Exterior Overcut is applied Too Short.

Resolution:

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

Crease is the Wrong Size

Problem:

  • Crease is applied at the Wrong Size.

Resolution:

Expand
titleOpening Adjustment Definition

The Opening Adjustment controls the size of the object cut or applied with non-blade cartridges.

Crease is Applied at the Wrong Depth When Using a SKU

Problem:

  • The Crease is applied at the Wrong Depth When Using a SKU.

Resolution:

  • The Blade Depth is too Deep, Decrease the Depth Bias.

  • The Blade Depth is too Shallow, Increase the Depth Bias.

  • See Depth Bias for additional information.

Expand
titleDepth Bias Definition

The Depth Bias is used to calculate the properBlade Depth when the SKUselected for the matboard contains the Matboard Thickness.

Troubleshooting Button 

Info

  • Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Expand
titleTroubleshooting Button Definition

The Troubleshooting Utility allows you to bring in a single opening and automatically selects the correct Cartridge tab and Bevel Type to configure.

Set Box Defaults

Expand
titleDefault Settings for the Box Utility

Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.