Versions Compared

Old Version 9

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 10

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Check Software Measurements

Check the software measurements to make sure that images taken with the camera are displayed at the correct scale, so that art, mats and frame moulding will display proportionally correct.

  • Open the FrameShop software and click on Visualize.

  • Place a measuring tape on the design table. 

  • If there is more than one device available, select the desired camera from the dropdown control on the Camera Capture Screen.

Info

  • A photo of the measuring tape is displayed.

  • Click the Set New Scale button.

  • Draw a box horizontally Horizontally along the ruler Ruler; take as long of a measurement as possible as this improves the software's measurements.

Image RemovedImage Added

  • A screen opens requesting the width measurement Width Measurement - enter the specific width that was measured within this box.

  • Click OK. 

Info

  • The scale Scale for the camera is now set.

Measure a Piece of Art

Info

Measure a piece of art Art taken with the camera Camera to make sure that the scale Scale is set correctly, so that art Art and moulding Moulding will display proportionally correct.

  • Click the Take Picturebutton.

  • Position a piece of art Art under the camera and center it in the field of view.

  • Click Take Picture.

  • Click on the Art Regions Tab.

  • Click Add New Art Region button.

  • Draw a selection box around the art Art.

  • The dimensions of the image displays on the Selected Region width and height boxes.             

  • The dimensions of the image should be correct, within approximately 1/8 inches. If the dimensions are correct and the image still appears “square,” then the camera is calibrated Calibrated at this specific fixed zoom point Fixed Zoom Point.

Calibration Complete 

Info

  • The camera Camera is now calibrated Calibrated and will remain calibrated as long as the camera is not physically moved.

  • If the camera mount Camera or Camera Mount is moved, the entire procedure must be repeated.

  • When saving a project to the database or to a file, the scale setting Scale Setting is saved with the project.

  • Thus, if using different zoom points and recalling a project from storage may require the scale Scale to be set again for the next new project started.

  • For fixed zoom Fixed Zoom, the software only remembers one scale value One Scale Value and that value will be changed when loading a prior project from storage.

...