Content Comparison

Click the Align the Head button to Align the Head into the cutting position and power up the motors in preparation of cutting a mat.

Optionally, if you click the Cut button when the motors are disengaged, it will prompt you to Align the Head.

After the Head is Aligned, itwill then Cut the mat.

When you click Cut, you will get a message displaying which clamps should be rotatedThe CMC will do an Interference Check to see if any of the clamps are in the way of the current cut sequence.

Rotate the indicated clamps as described below and click Continue.

Push To rotate the Clamp out of the way, push the indicated clamp toward the board Board to release the pressure.

Rotate the indicated clamps Clamps so that they are facing away from the center of the boardBoard. 

Make sure that the indicated clamps are facing away from the center of the board.

When the clamps Clamps are engaged, they will be retracted flush with the boardBoard.

For the next cutting job, the clamps Clamps should be rotated back toward the center of the board Board to hold down the next mat. 

Rotate the foot block Foot Block into the 12 O’Clock position. 

Holding it about an inch above the bottom rail, slide the gantry Gantry and the head Head assembly to the left edge of the CMC until it stops. 

It will stop against the Magnetic Stop.

Then slide the head Head down until the footblock Foot Block rests against the Head Alignment Stop.

Click the Align the Head button or the Cut button to finish the Align the Head sequence.

On the Alignment screen, make sure that the Pen, Vinyl and Creasing tools are not in the footblock Foot Block.

Click Continue on the Alignment screen.

Head will align to the home Home position.

If you clicked the Align the Head button, the CMC is now aligned Aligned and ready to cut.

If you clicked the Cut button, the CMC will now begin to cut the mat.

Click the Disengage button to disengage power to the motors of the cutting Head on the CMC. 

User will be prompted to Click OK to release the motors.

Grasp the Head and then Click OK. 

The motors will be disengaged and the Head will drop. When the motors are disengaged, the Head and the Gantry can be moved freely by hand.

The head Head will need to be Aligned again before the next mat is cut.