Versions Compared

Version Old Version 11 New Version 12
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Align the Head on the CMC Z (9000z)

  • Click the Align the Head button to Align the Head into the cutting position and power up the motors in preparation of cutting a mat.

Info

  • Aligning the Head will only get the machine ready to cut, but not actually cut.

Info

NOTE: The hardware photos below may slightly differ from your specific model but the steps are still the same.

Align the Head Button vs. the Cut Button

  • Optionally, if you click the Cut button when the motors are disengaged, it will prompt you to Align the Head.

  • After the Head is Aligned, itwill then Cut the mat.

...